Before being able to use your Pergolux pergola and it's accessories you will need to program the remote control. To do this, you can watch the following video: Programming the S3 remote control. Alternatively, here is a written guide:
Please note- All LEDs on the control box should be lit up when connected to power.
Step 1: Activate Programming Mode
- Press and hold the corresponding "programming button" on the control box for about 7 seconds until the LED indicator flashes continuously. The control box is now in programming mode.
- For Group Control, all LEDs will flash.
💡 Notes:
â‘ If no programming occurs within 15 seconds, the control box will exit programming mode.
â‘¡ Each channel of the control box can be paired with up to 6 RF remote controls.
Step 2: Programming with the RF Remote Control
While the control box is in programming mode (LED blinking):
- Select the desired channel on the remote (e.g., LED to Channel 1, Motor to Channel 2, etc.).
- Press the "UP" arrow on the remote.
- The LED indicator on the control box will flash quickly 3 times – the pairing is successful, and the control box will exit programming mode.