Below is a guide on how to use your Pergolux LEDs with the S3 remote control.
Turning the LED Strips on:
Press the “UP” arrow on the remote control, the LED Strips will turn on.
Turning the LED Strips off:
Press the “Down” arrow on the remote control, the LED Strips will turn off.
Changing the colour (RGB LEDS Only)
When the LED Strips are on, press the “Stop” button to switch to the next colour (refer to the colour table below).
Increasing brightness continuously:
When the LED Strips are on, press and hold the “UP” arrow on the remote control for about 1.5 seconds. The LED Strips will continue to increase brightness at a constant speed until they reach the brightest setting.
During the increase, press any of the “Up/Down/Stop buttons to stop increasing and save the brightness at the point where you stopped.
Decreasing brightness continuously:
When the LED Strips are on, press and hold the “Down” arrow on the remote control for about 1.5 seconds. The LED Strips will continue to decrease brightness at a constant speed until they reach the darkest setting.
During the decrease, press any of the “Up/Down/Stop buttons to stop decreasing and save the brightness at the point where you stopped.
Increase or decrease brightness by one level:
Press the “Up + Stop” button to increase the brightness by one level.
Press the “Down + Stop” button to decrease the brightness by one level.
Note: The factory-set default colour is white. There are a total of 21 brightness levels (0 to 20), with the default brightness level of the LED Stripes set to level 10. The PERGOLUX APP can set the brightness to a very low level (below the brightness level 0 of the RF transmitter control), and it will automatically return to the default level of 10 when the control box is turned off and back on again.